Installing the seat rail, left hand side
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- the rail on the bracket / cross member
- two plus one screws
- the two screws for the front-rear adjustment motor.
Install the end mounting. See Seat belt buckle end mounting
Install the seat. See Removing power seats, tilting .
NOTE:
Removed seat rails must always be checked for movement. Use Vernier calipers to measure from the fixed to the moving component. Both rails should have the same measurement. If not, adjust one of the rails. If the rails do not have the same measurements the seat does not run parallel. This leads to increased wear and noise.