Installing WHIPS system

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

The green indicator (G) supplied must only be installed on the deformation element in cars up to the following chassis number.

S80: -167986

Install:

the deformation element (F), the plastic washers and the O-ring
the spindle (E)
the nut (B). Tighten the nut. Tighten to 17 Nm +/-1 Nm
the spring (D).

Position the seat in the normal position.

NOTE:

The two plastic washers and the O-ring must be correctly positioned. Check that the indicator pin is intact and is correctly positioned after installation.

Reinstall all other removed components.