Positioning in relation to the channels in the foam filling

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying End Of The Pad Not Up On Flat Surface

Courtesy of VOLVO CARS OF NORTH AMERICA.

If the heater pad terminates at the channel, position it as illustrated.
NOTE:
The end of the pad must not be up on the flat surface.

Fig 2: Identifying Proper Pad Fill Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

If the pad and/or wire in the heater pad is to be positioned in the channel, the pad must follow the foam filling as illustrated. Failure to do so may result in loads to the pad and/or wire that damage the pad. (The type of seam on the upholstery may cause wear in the long term).