Calibrating sun roof module (SRM)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sun Roof Switch

Courtesy of VOLVO CARS OF NORTH AMERICA.

The sun roof must be closed.

Ignition in position I.

Press the sun roof switch so that the sun roof is in the tilt position.

Release the switch.

Press the switch (in the tilt position) in again for at least 5 seconds so that the sun roof closes.

Release the switch.

The calibration is complete.

NOTE:

If the sun roof has not moved to the correct position, carry out calibration again.

HINT: If the sun roof has still not moved to the correct position:

HINT: Press the sun roof switch so that the sun roof moves to the rearmost position (completely open).

HINT: Release the switch.

HINT: Press the switch (in the completely open position) in again for at least 5 seconds so that the sun roof closes.

HINT: Release the switch.

HINT: Close the sun roof and carry out calibration again. See instructions 1 and 2 above.

For further information on the sunroof, see

See Design

See Function