Assemble the ABS hydraulic modulator and the bracket
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The ABS hydraulic modulator is filled with brake fluid. It is important that the plugs are not removed until the brake pipes are to be connected.
Install the new ABS hydraulic modulator
Install the new ABS hydraulic modulator on the bracket. Tighten the mounting screws. Tighten to 8 Nm .
Hold the vacuum hose to one side and carefully install the bracket in the car (the hose between the bracket and the side member).
Connect the pump motor connector to the control module. Tighten the mounting screws. Tighten to 8 Nm .