LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Media, Communication And Navigation - Specifications, Electrical/Electronic) >> Signal Specification, TV Executive. Rear Seat Entertainment, Generation 3.1/3.2 (75TH Anniversary Edition; 2002) >> Signal specification, TV Executive

Signal specification, TV Executive

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
U= DC voltage in volts (V) Ubat = Battery voltage (V)
    Ulow = Voltage approximately 0 V
Fig 1: Identifying M2D Control Module (Fortv Executive. Rear Seat Entertainment, Generation 3.1/3.2, Premier TV Receiver) Connector
GLL104056Courtesy of VOLVO CARS OF NORTH AMERICA.
M2D control module (for the TV receiver)

Terminal in control module connector N1  Signal name  Signal type  Ignition on  Signal specification 
N1-1 VIDEO-in Video signal TV Analog signal 1Vp-p
+-0.2V
N1-2 C-SYNC-in Composite synch, TV Analog signal 0-5V
N1-3 - - - -
N1-4 - - - -
N1-5 - - - -
N1-6 +B-TV 30-supply to the TV tuner U bat -
N1-7 GND-TV Signal ground TV U low -
N1-8 SHIELD-GND Screen ground U low -
N1-9 +B 30-supply to the M2D control module U bat -
N1-10 RHEO+-in Background lighting, TV U low U bat ,
when the BRIGHTNESS switch is pressed
N1-11 REMOCON-out Remote control TV Digital signal 33.3 kHz carrier wave when the remote control is pressed
N1-12 - - - -
N1-13 GND Ground U low -
N1-14 - - - -
Fig 2: Audio Control Module (Cable Between Audio Module & CD Changer/Navigation Unit)
GLL104159Courtesy of VOLVO CARS OF NORTH AMERICA.
M2D control module (to the audio unit)

Terminal in control module connector N4  Signal name  Signal type  Ignition on  Signal specification 
N4-1 MSCK Clock signal Digital signal Melbus protocol
N4-2 SIG-GND Signal ground U low -
N4-3 EXT-ACC 15 supply U bat -
N4-4 MDATA Data signal Digital signal Melbus protocol
N4-5 MBUSY Busy signal Digital signal Melbus protocol
N4-6 LCH-OUT Left audio channel Alternating current when there is sound to the loudspeaker 150m Vrms +/- 38mV (1kHz 30% mod)
N4-7 RCH-OUT Right audio channel Alternating current when there is sound to the loudspeaker 150m Vrms +/- 38mV (1kHz 30% mod)
N4-8 - - - -
H FG Screen ground U low -
Fig 3: RTI Control Module (To TV Receiver) Connector Terminals
GLL104161Courtesy of VOLVO CARS OF NORTH AMERICA.
M2D control module (to the audio unit)

Terminal in control module connector N5  Signal name  Signal type  Ignition on  Signal specification 
N5-1 SIG-GND Signal ground U low -
N5-2 LCH-IN Left audio channel Alternating current when there is sound to the loudspeaker 150m Vrms +/- 38mV (1kHz 30% mod)
N5-3 - - - -
N5-4 RCH-IN Right audio channel Alternating current when there is sound to the loudspeaker 150m Vrms +/- 38mV (1kHz 30% mod)
N5-5 - - - -
N5-6 - - - -
N5-7 - - - -
N5-8 - - - -
N5-9 - - - -
N5-10 EXT-ACC 15 supply U bat -
N5-11 MBUSY Busy signal Digital signal Melbus protocol
N5-12 MSCK Clock signal Digital signal Melbus protocol
N5-13 MDATA Data signal Digital signal Melbus protocol
H FG Screen ground U low -
Fig 4: Connector, Green (16- Pin)
GLL104026Courtesy of VOLVO CARS OF NORTH AMERICA.
NOTE:

Before taking readings, the breakout box must be connected and the ground terminal must be checked. See Checking the ground terminals .

DC voltage in volts (V) Ulow = Voltage near V
  Ubat = Battery voltage

TV receiver terminals M1-M16 correspond to terminals #25-#40 on the breakout box.

Control module terminal  Breakout box terminal Signal type  Ignition on  Other 
M1 #25 Video signal, TV Analog signal 1 V p-p +/- 0.2 V
M2 #26 Synchronizing signal, TV Digital signal 0-5 V
M3 #27 - - -
M4 #28 - - -
M5 #29 - - -
M6 #30 - - -
M7 #31 30 supply Ubat -
M8 #32 Signal ground, TV signals Ulow -
M9 #33 Screen ground, TV signals Ulow -
M10 #34 - - -
M11 #35 - - -
M12 #36 - - -
M13 #37 Signal, remote control TV Digital signal 33.3 kHz carrier wave when
the remote control is pressed
M14 #38 - - -
M15 #39 Ground (Measured to battery negative terminal) Ulow -
M16 #40 - - -