Connecting the breakout box

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Ignition off.
Expose the car phone module according to Radio cassette player, replacing .

Check that the male and female terminals on the unit connectors are undamaged and secure (cannot be pressed in). Check that the cables to the female terminals are secured to the terminal pins.

Connect adapter 9511463 (terminal A, B, C) or 9511509 (terminal E) to the unit connectors (to the wiring) and connect the breakout box 9511428 to the adapter.

Keypad/car phone module terminals:

Terminals #A1-#A22 correspond to terminals #1-#22 on the breakout box.

Terminals #B1-#B16 correspond to terminals #25-#40 on the breakout box.

Car phone box terminals:

Terminals #C1-#C16 correspond to terminals #25-#40 on the breakout box.

Car phone handset terminals:

Terminals #E1-#E8 correspond to terminals #32-#39 on the breakout box.

The breakout box is designed to facilitate reading off the control module input and output signals when the control module is connected; and the cable and component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuited cables and damage to the connector pins.

For information about signals and other values, see Signal specification, Keypad unit/carphone module (PHM) .