Removing components
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- the screw holding the engine stabilizer brace to the bracket on the engine
- the screws holding the engine stabilizer brace to the suspension turrets
- the engine stabilizer brace
- the inlet hose for the turbocharger (TC) from the air cleaner (ACL) cover. Place it to one side
- the charge air pipe over the engine. Seal the openings
- the upper timing belt cover
- the cover over the ignition coils
- the brackets for the engine stabilizer brace on the cylinder head
- the camshaft position (CMP) sensor housing
- the trigger wheel
- the cover at the rear edge of the intake camshaft. Insert a screwdriver into the center of the cover and then pry the cover off.NOTE:
Clear up any oil spillage under the cover.
- the servo reservoir and the expansion tank. Lift up and place on top of the engine.WARNING:
Ensure that no power steering fluid is spilled. Extremely flammable.