Replacing The Bulb Holder In The Rear View Mirror Unit
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
The upper electronic module (UEM) is integrated in the rear view mirror. For more information about removing the rear view mirror, see Replacing the upper electronic module (UEM), or the rear view mirror .
Removal
- Remove the lens.
- Remove the 2 screws at the front edge.
- Press the 2 rear catches forward.
- Press two of the catches on one side inwards. Remove the bulb holder.
- Disconnect the 2 connectors.
- Disconnect the ground lead.
HINT: Only certain versions of the upper electronic module (UEM) have a ground lead.
- Remove the cover over the connector for the rear view mirror and control module.
- Flip the anti-dazzle button toward the lens. Disconnect the connector in the rear view mirror and control module by pressing the catch through the opening. Use a screwdriver.
- Remove the bulb holder together with the rear view mirror and control module.
Installation
- Connect the connector for the rear view mirror and control module.
- Reinstall the cover for the rear view mirror and control module connector.
- Connect the 2 connectors.
- Install the ground lead.
- Press the bulb holder into place.
- Install the 2 screws at the front edge.
CAUTION:
Check that the microphone cable is not trapped (if applicable).
- Install the lens.
HINT: Only certain versions of the upper electronic module (UEM) have a ground lead.