LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Throttle Body (Electronic Throttle Module) - Removal And Installation) >> Engine Mechanical >> Throttle body (electronic throttle module (ETM)), replacing >> Throttle body (electronic throttle module (ETM)), replacing (B5xx4T -2001) >> Installing >> Installing the fan shroud

Installing the fan shroud

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cable Harness Secured Using Tie Straps
GLL147982Courtesy of VOLVO CARS OF NORTH AMERICA.

Carefully lower the fan shroud and align with the holders. Route the cable harness behind the holder (3).

Tighten both the mounting screws

Press the hose down from the expansion tank into the holder on the fan shroud

Secure the cable harness by the fan shroud using tie straps (1) and (2). See the illustration.

Install the evaporative emission system (EVAP) valve.

Connect the engine cooling fan (FC) connectors.

scientia non olet · About LEMON Manuals