Install the master cylinder
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- the master cylinder on the power brake booster. Tighten to 25 Nm
- the brake pipes in the mounting on the firewall.
NOTE:
Ensure that the rubber seal is in position between the master cylinder and the power brake booster during installation.
Install:
- the connectors for level control and the power brake booster
- the clamp with the tie strap around the connector.