Check that the boot is in position on the drive shaft

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inserting Screwdriver Between Drive Shaft And Boot

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use a well rounded screwdriver.

Carefully insert the screwdriver between the drive shaft and boot. Ensure that the boot is in position on the drive shaft (the inner rib against the joint).

Install a new clamp. Use pliers 9512619 .

Install the drive shaft in the transmission

See Install the drive shaft in the gearbox, the stub axle and the control arm .