Measuring before removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Over Wheel Spindle/Spring Strut At Upper Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

The measurements are made so that the same camber angle can be obtained when installing.

Measure over the wheel spindle / spring strut at the upper screw as shown in the illustration.

Before measuring clean off any dirt from the measuring surfaces.

Note the measurement.