Installing the nuts securing the ball joint to the control arm and the anti-roll bar to the link rods

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Ball Joint Nut

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the nuts for the ball joint and control arm: Counterhold with a Torx spanner so that the boot does not rotate. Tighten to 80 Nm

Install the anti-roll bar and link rods: Use new nuts. Tighten to 50 Nm.