Removing the control module: Preparations
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The customer-programmed data must be read off before the control module is replaced. The information must then be entered into the new control module after it has been installed. This is performed via VIDA vehicle communication.
NOTE:
The driver information module (DIM) must not be replaced at the same time. This would erase the mileage.
NOTE:
Before disconnecting the control module's connector, remove fuses 11C/32, 11C/25 and 11C/21.