Installing removed components
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- the heated oxygen sensor (HO2S) connector
- the rubber mountings for the exhaust pipe
- SIPS (side impact protection system) member
- the four screws for the SIPS (side impact protection system) member. Tighten to 24 Nm .
Route the hose for the EVAP canister to the correct position and press the joints together
Install the four nuts and the screw holding the steering gear. Use new nuts and a new screw. Tighten to 50 Nm .
Clip the cable in position.
Install:
- the ball joints. Use new nuts. Tighten to 80 Nm . Counterhold using a Torx wrench so that the ball joint boot is not damaged
- the anti-roll bar links. Use new nuts. Tighten to 50 Nm . Counterhold using a Torx wrench so that the boot is not damaged.
Install:
- the lower torque rod. Tighten the two screws. Tighten to 10 Nm
- the oil pipe for the steering gear from the snap fasteners along the sub-frame
- the screw clip for the steering gear return line
- the engine block heater and the fuel line to the engine block heater if applicable
- the screw for the cable duct
- the screw for the ground lead.