Replacing seat belts after a collision: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

The ignition must not be switched on when the SRS ignition cable connector is being removed or installed.

WARNING:

Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected non-deployed seat belt tensioner. This could deploy it.

WARNING:

After a collision, the seat belt (inertia) reels and tensioners must always be replaced. This applies even if no one was seated in the passenger seat at the time of the collision.

WARNING:

Seat belt tensioners must never be unscrewed, repaired or moved to another vehicle. For information about what to do with used seat belt tensioners, see Handling non-deployed SRS-components .

Remove:

For front seats see Removing seat belts from the front seats .

For rear seats see Removing the rear-seat seat belts .