Installing backrest cushion upholstery
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For tightening torques, see General tightening torque .
Install:
- the upholstery on the backrest
- the three half moon clips on the inside of the reverse of the backrest
- the two elastic attachments in the inside of the reverse of the backrest
- one half moon clip in each side of the front-rear channels.
Install the upholstery up to the first lateral channel. There must be two half moon clips per each front-rear channel.
Install the upholstery all the way down.
Install five half moon clips at the bottom edge of the backrest.
Fold the backrest to the normal position.
Install:
- the backrest adjustment knob. Push the knob straight in
- the lumbar support knob
- the cover.
Tension the lumbar support.