Removing rivet

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Special tools
	T9814075 SPRAY GUN Tool number: T9814075 Tool description: SPRAY GUN Tool boards:

Materials:
Designation	Part number
Thin rustproofing agent	1161682

NOTE:

If the pop rivet spins, drill at a 45° angle against the pop rivet.

Pay attention to heat generation when drilling in pop rivet mounted in plastic part.

Remove drill burrs and any remains of the rivet.

If possible, put tape on the back to catch pop rivet.

Fig 1: Applying Thin Rustproofing Agent

Courtesy of VOLVO CARS OF NORTH AMERICA.

To avoid rattling if it is not possible to remove remains of rivet.

9814075

CAUTION:

Make sure that rustproofing agent does not run out, discoloring the upholstery or other.