LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Engine And Transmission - Removal And Installation) >> Engine Mechanical >> Engine/transmission, removing/installing >> Drive shaft, right, replacing >> Installation >> Installing the drive shaft in the gearbox

Installing the drive shaft in the gearbox

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Bearing Cap And Drive Shaft Support Bearing
GLL109802Courtesy of VOLVO CARS OF NORTH AMERICA.

Lubricate the drive shaft mating surface. Use wheel bearing grease P/N 116 1241-3 (80 g).

Install the drive shaft on the gearbox and the mounting for the pilot bearing with the bearing cap and the 2 M8 screws. Tighten.

Install the drive shaft to the wheel hub. See:

scientia non olet · About LEMON Manuals