Installing brake components on the wheel spindle
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- the brake caliper. Use new screws. Tighten to 100 Nm
- the screw for the drive shaft. Use a new screw. Counterhold using a screwdriver in the brake disc vents. Tighten. See Summary of tightening torques for specific components
- the ABS sensor. Check that the sensor seat in the wheel spindle is free of dirt. Tighten to 10 Nm .
Install the wheel
See Installing wheels .