Installing the front bumper

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For tightening torques, see: Tightening torque .

Fig 1: Aligning Lugs On Bumper In Channels On Slide Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the quick-release connector for the headlamp washer
the 2 connectors for the fog lamps.

Guide the lugs (3) in to the grooves on the side bracket (4).

Press at the top so that the lugs engage.

Press in the bumper cover as far as it will go.

HINT: This operation is easier with two people.

Fig 2: Identifying Bumper Cover Clips

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the 2 x M8 screws. Tighten
the 6 clips, on the upper side of the casing
the 2 clips (5) on the underneath of the bumper
the trim strip on the left and right-hand sides
the screw (1), 1 per side. Tighten.