Installing the condenser
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fill the condenser with oil. See Oil air conditioning (A/C) system, filling .
NOTE:
Always use new O-rings lubricated with compressor oil.
Install the condenser with the 2 lower retaining screws (M6). Tighten.
Guide the left AC pipe into place against the condenser connection and fasten with the clip.
Install:
- the right AC pipe with the 1 M6 screw and tighten.
- the pressure sensor and tighten
- the connector.
Raise the vehicle.
Install:
- the condenser's 2 upper mountings (M6) and tighten
- the left AC pipe (1 M8) and tighten
- the left headlight:
- For -2004 see: Headlamp/bulb, replacing
- For 2005- see: Headlamp/bulb, replacing .