Installing the propeller shaft, front
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Check carefully that the mating surfaces on the propeller shaft and flange are clean.
NOTE:
If the same propeller shaft is to be reinstalled, install the propeller shaft using the marking made earlier. See Removing the front propeller shaft .
Tightening the propeller shaft CV joint
Use new screws.
Tighten the screws. See Summary of tightening torques for specific components .