Installing members and the exhaust system
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Tighten:
- the 4 M8 screws for the support for the center bearing
- the 2 M8 screws for the propeller shaft center bearing.
Install:
- the front member on the bodywork, the exhaust pipe and the three-way catalytic converter (TWC), 4x M8. Tighten
- the brake pipe in the mountings in the member
- the rear exhaust pipe assembly. Use a new gasket between the three-way catalytic converter (TWC) and the rear exhaust system.