Installing the propeller shaft, front

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Tightening Propeller Shaft

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check carefully that the mating surfaces on the propeller shaft and flange are clean.

NOTE: If the same propeller shaft is to be reinstalled. Install the propeller shaft according to markings, see Removing the front propeller shaft .

Tightening the propeller shaft CV joint

Use new screws.

First tighten the screws crosswise. Tighten to 8 Nm . Then tighten to 30 Nm .

Use counterhold 9995743 .