Installing members and the exhaust system

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Pipe/Catalyst

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten the screws for the support for the center bearing. Tighten to 25 Nm .

Tighten the screws for the propeller shaft center bearing. Tighten to 25 Nm .

Install:

the front member on the bodywork, the exhaust pipe and the three-way catalytic converter (TWC). Tighten to 25 Nm
the brake pipe in the mountings in the member
the rear exhaust pipe assembly.