Adjustment Of Light Propagation: Adjustment

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Always adjust the light propagation according to the local law.

Fig 1: Adjusting Beam Vertically And Horizontally (1 Of 2)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition and low beam on.
Check the amperage so there are enough current for correct light propagation.
Undo the cap, over the adjusting screw for the light propagation laterally (X), by drawing upwards.
CAUTION: Always adjust the light propagation with low beam on.

Fig 2: Adjusting Beam Vertically And Horizontally (2 Of 2)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Adjust the light propagation in vertical height (Y) by using a socket screw as shown.
Adjust the light propagation laterally (X) by using a socket screw.
HINT: Use socket screw Ø 6 mm.

WARNING: Always adjust the light propagation according to the local law.