When Only Replacing The Front Crankshaft Seal
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of VOLVO CARS OF NORTH AMERICA.
- Remove the old seal using a screwdriver or: 9995919
.
- Clean the mating surface
- Grease and install a new seal.
Use tool 9995455
.
- Press in the seal using a drift and the crankshaft center nut.
NOTE:
Make sure that the crankshaft does not rotate when pressing in the crankshaft seal.