Test Phase

In order for the quick test to start, the status of this parameter must be: NOT RUNNING.

The parameter indicates the phase of the test.

• REFERENCE 1 = Reference phase for leaks of 0.5 mm and function test of the leak diagnostic unit is running
• MAJOR LEAK = Diagnostic for major leaks is running
• MINOR LEAK = Diagnostic for minor leaks is running
• REFERENCE 2 = Reference phase for leaks and function test of the leak diagnostic unit is running. This phase is only run if leakage is detected in the MINOR LEAK or MAJOR LEAK test phase
• NOT RUNNING = No quick test or diagnostic is running.

For more information about these parameters, see Test phases .