Measuring The Line Pressure
- Connect the pressure gauge according to Connecting fuel pressure gauge
- Remove the soundproofing panel
- Remove the fuel pump (FP) relay (CMI 12 in the passenger compartment)
- Connect a cable to the relay base.
Read off the line pressure from the pressure gauge. The line pressure must be 375-395 kPa.
Check the residual pressure if the fuel pressure is OK.
Remedy as necessary.
Other information:
- For the location of and to replace the fuel pump (FP) relay, see Central electronic module (CEM), replacing
- For the location of and to replace the fuel pump (FP), see Level sensor, fuel tank/fuel pump, replacement
- For the location of and to replace the fuel filter, see Replacing the fuel filter
- To disconnect the pressure gauge, see Disconnecting fuel pressure gauge