LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition And Control Systems - Cleaning, Inspection And Adjustment >> Checking Fuel And Residual Pressures (B5204T5; 2004-2007) >> Checking Fuel And Residual Pressures >> Injector/Pulse Damper, Replacement >> Finishing

Injector/Pulse Damper, Replacement: Finishing

Position the mounting rail. The injectors may need to be pulled away from the fuel rail a few millimeters to install the rail.

Tighten the mounting rail to the fuel rail.

Press down the fuel rail. Check that all injectors are correctly positioned.

Screw the fuel rail into place. Use new screws. Tighten to 10 Nm  .

Install all connectors on the injectors.

Press the quick-release connector together until a clicking sound is heard. See Fuel line, lock .

Fig 1: Identifying Plastic Hoses Between Turbocharger, Charge Air Cooler & Air Cleaner/Turbocharger
GLL102988Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies only to B6xx4T  . Remove the seals. Install the plastic pipes between the turbocharger (TC) / charge air cooler (CAC) and the air cleaner (ACL) / turbocharger (TC).

Fig 2: Identifying Upper Section Of Intake Manifold
GLL102989Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies only to B6xx4S engines  . Remove tool 999 5723. Clean the gasket faces and install a new gasket  . Install the upper section of the intake manifold. Tighten to 17 Nm  . Start from the center and tighten alternately.

scientia non olet · About LEMON Manuals