Diagnostic trouble code (DTC) information ECM-8410

Condition 

If the 5 volt supply circuit for the mass air flow (MAF) sensor, boost pressure sensor, air conditioning (A/C) pressure sensor and fuel tank pressure sensor has a voltage higher than 6 V (high signal) or lower than 4 V (low signal) the control module interprets it as a fault and ECM-8410 is stored.

Substitute Value 

• None.

Possible Source 

Signal too high: 

• short-circuit to battery voltage in the 5 volt supply cable
• Defective mass air flow (MAF) sensor
• Defective boost pressure sensor
• Defective air conditioning (A/C) pressure sensor.

Signal too low: 

• short-circuit to ground in the 5 volt supply cable
• Defective mass air flow (MAF) sensor
• Defective boost pressure sensor
• Defective air conditioning (A/C) pressure sensor.

Fault symptom[s] 

• Driving/Poor performance/lacks power
• Driving/Engine stalls/Unsure when/at all times