Checking The Wiring

Check the resistance between connector terminal #1 and terminal #2 on the camshaft reset valve. The resistance must be approximately 3.7 Ω.

Check the signal cable between engine control module (ECM) terminal #A12 and connector terminal #2 (on the camshaft reset valve). Check for an open-circuit.

Remedy as necessary.

Other information 

• See Connecting the breakout box
• See Signal specification
• With the ignition on and the reset valve connector disconnected, the voltage at connector terminal #1 must be approximately Ubat and at connector terminal #2 it must be a pulse modulated signal with a peak voltage of approximately Ubat and with a frequency of approximately 250 Hz
• See Checking wiring and terminals

Fig 1: Identifying Camshaft Reset Valve Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Camshaft Reset Valve (Continuous Variable Valve Timing (CVVT))

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification