Checking for oil leakage and replacing the oil level sensor
NOTE:
If the diagnostic trouble codes (DTCs) ECM-5600 and ECM-5630 are stored simultaneously, ECM-5600 must be remedied first.
- Checking the engine for oil leakage
- Also check the oil level sensor connector. Check for loose connections, contact resistance or oxidation.
HINT: This diagnostic trouble code (DTC) may be stored if the engine oil is significantly mixed with fuel or coolant for example.
Try a new oil level sensor if no fault is found and the fault is permanent.
Remedy as necessary.
Other information:
- See Contents
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- To access or replace the oil level sensor see Oil level sensor, replacing .
- Continue
Refer to Verification