Checking the canister purge (CP) valve

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect the hose between the canister purge (CP) valve and the EVAP canister from the canister purge (CP) valve.
Start the engine and let it idle.
HINT: Listen to or feel the valve to ensure that it is not activated. The signal can be stopped in the event of uncertainty. Feel with fingers or connect a vacuum gauge to the valve connection to determine whether there is leakage when the canister purge (CP) valve is off. There must not be any leakage.

Other information:
- To access or replace the canister purge (CP) valve:
- Remove the intake manifold between the front cover plate and the air cleaner (ACL) housing.
- Disconnect the canister purge (CP) valve connectors.
- Pull off the valve from the bracket on the fan shroud.
- Mark up and pull off the hoses from the valve.
- Install the hoses according to the marking.
- Install the canister purge (CP) valve on the bracket on the fan shroud.
- Connect the canister purge (CP) valve connectors.
- Install the intake manifold between the front cover plate and air cleaner (ACL) housing.
Fig 2: Identifying VCT2000 Diagnostic Tool
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the canister purge (CP) valve OK?