Checking the wiring

WARNING:

Before fault-tracing can begin, the engine cooling fan (FC) connector must be disconnected to prevent the engine cooling fan (FC) engaging. Diagnostic trouble code (DTC) ECM-6110 engine cooling fan (FC) control module may be stored. After fault-tracing the connector must be reconnected.

NOTE:

This diagnostic trouble code (DTC) is stored if the engine coolant temperature (ECT) sensor freezes. This may happen if the coolant level is low or there is too little glycol in the coolant. Check the engine coolant level and its freezing point. Remedy as necessary.

HINT: The diagnostic trouble code (DTC) can be caused by a thermostat that doesn't open.

Fig 1: Identifying Ignition Switch OFF Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Check the ground lead between control module terminal #A60 (#A60) and engine coolant temperature (ECT) sensor terminal #2. Check for an open-circuit
Reinstall the components, reconnect the connectors etc.
Other information
- See Contents
- To connect the breakout box / access the control module, see connecting the breakout box
- To access the engine coolant temperature (ECT) sensor, see Temperature sensor engine coolant, replacing
- For resistance values, see component specifications
- For information about signals, see ELECTRICAL SYSTEM
Fig 3: Identifying 2-Bit connector
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Ohmmeter
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 5: Identifying 2-Bit connector Side View
Courtesy of VOLVO CARS OF NORTH AMERICA.

Were any faults found in the cable?

YES
Refer to Verification
NO
Refer to Checking the engine coolant temperature (ECT)