LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Variable Valve Timing - Checking, Adjustment, Removal & Installation >> Engine Timing/Timing Belt >> Variable valve timing unit, checking and adjusting >> Install and adjust variable valve timing unit/gear pulley on camshafts >> Install tensioner/damping unit

Install tensioner/damping unit

Fig 1: Identifying Tensioner/Damping Unit
GLL108819Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that there is no visible leakage.

Press the tensioner/damping unit together using: 9995456 .

Position the tensioner/damping unit in the tool. Screw the tool center nut to the bottom.

Wait until it is compressed and then install a lock pin in the piston.

NOTE:

The tensioner damping unit must be replaced if there is leakage or there is no resistance when pushed in or if it cannot be pushed in.

Install the tensioner/damping unit. Tighten to 25 Nm  .

scientia non olet · About LEMON Manuals