Remove front timing cover

NOTE:

Since the illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Fig 1: Identifying Thermostat Housing Locks

Courtesy of VOLVO CARS OF NORTH AMERICA.

Loosen hose thermostat housing-expansion tank from the thermostat housing by pressing in the locks, then press in the connection against the thermostat housing, then pull out the connection.

Fig 2: Identifying Expansion Tank

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Make sure that the belt cover has cleared the nipple on the thermostat housing before the cover is pulled up, to prevent damaging the nipple.

Remove:

the air duct, cover, surround and control module box
the hose between the thermostat housing and the expansion tank
the front timing belt cover.