Installing components

Fig 1: Identifying Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the trigger wheel. Tighten the screw
• the camshaft position (CMP) sensor housing. Tighten the screws
• the upper and lower engine stabilizer brace
• the cover over the ignition coils
• the charge air pipe over the engine. Remove the seals
• the intake air hose and air cleaner (ACL)
• the intake pipe between the air cleaner (ACL) and the front cover plate
• the engine stabilizer brace. Tighten the screws at the suspension turrets and the screw for the engine bracket. Check the engine compartment. Wipe the engine compartment clean.