Installing the camshaft belt
NOTE:
The component can be reused unless it has been subjected to abnormal mechanical stress, damage or oil contamination.
Install the camshaft belt over pulley wheel on the crankshaft.
Install the oscillation damper. Tighten the center nut to 180 Nm . Use counterhold 9995433 .
Remove the counterhold and install new screws. Tighten the screws to 25 Nm . Angle-tighten 30°
Install the new belt in the following order:
- crankshaft
- idler pulley
- intake camshaft pulley
- exhaust camshaft pulley
- water pump
- belt tensioner.