Removing components

Fig 1: Identifying Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the screw holding the engine stabilizer brace to the bracket on the engine
• the screws holding the engine stabilizer brace to the suspension turrets
• the engine stabilizer brace
• the inlet hose for the turbocharger (TC) from the air cleaner (ACL) cover. Place it to one side
• the charge air pipe over the engine. Seal the openings
• the upper timing belt cover
• the cover over the ignition coils
• the brackets for the engine stabilizer brace on the cylinder head
• the camshaft position (CMP) sensor housing
• the trigger wheel
• the cover at the rear edge of the intake camshaft. Insert a screwdriver into the center of the cover and then pry it off
  NOTE:

  Clear up any oil spillage under the cover.

• the servo reservoir and the expansion tank. Lift up and place on top of the engine.
  WARNING:

  Ensure that no power steering fluid is spilled. Extremely flammable.