Installing the oil pan

Apply liquid gasket 1161 059-9 to the oil pan. Use roller 9512767 .

Install: 

• new O-rings
• the Oil pan. Secure the Oil pan loosely using a few screws
• the remaining screws loosely.

Press the oil pan towards the transmission. Tighten the screws (1), (2), (3) and (4). See Summary of specific components and tightening torques . Tighten the screws (5). See Summary of specific components and tightening torques .

Tighten all screws in the screwed oil pan joint. Start at the transmission and continue forwards in pairs.

Install the screw for the bracket for the fuel line.

Connect the oil cooler to the pan. Use new O-rings  . Reinstall the pipe on the sub-frame.

Install: 

• a new oil filter
• the oil plug with a new gasket
• the oil dipstick and its pipe. Use a new O-ring.
  NOTE:

  Check that the O-ring is correctly positioned.

Fill with engine oil. Run the engine to operating temperature.

Check for oil leaks from the oil pan or oil cooler.

Install the splashguard under the engine.

Check the oil level. Top up if required.