Engine/transmission, installing: Finishing

Fig 1: Identifying Heated Oxygen Sensor Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect the connector to the pressure switch (Pressostat) in the drier bottle. Secure the wiring.

Tighten the lower screw on the cooler unit.

Connect the connectors to both the heated oxygen sensors (HO2S).

Fig 2: Identifying Splash Guard Under The Engine

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• the splash guard under the radiator
• the splash guard under the engine
• the front wheels. See Installing wheels
• the battery negative lead. Also read Battery, disconnecting .