Engine mount, right, replacing: Removal: Installation

Fig 1: Identifying Sub-Frame And Engine Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• the new engine pad
• use new screws  for the mounting in the sub-frame and engine. Do not tighten yet  .

• Carefully lower the engine and remove the mobile jack
• Tighten the screws against the engine. Tighten to 35 Nm  . Angle-tighten 90°  . Use bevel protractor 9512050
• Tighten the screws to the sub-frame. Tighten to 65 Nm  and angle-tighten 60°  . Use bevel protractor 9512050 .

• the splash guard under the engine. Tighten to 25 Nm 
• both the plastic nuts and the reinforcement panel holding the cover in the right fender liner
• the right front wheel. See Installing wheels