LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - Removal, Replacement And Installation >> Cylinder Head (B5244S6; 2003-2006) >> Cylinder head/gasket, replacing >> Installing the cylinder head >> Installing the rear camshaft seal

Installing the rear camshaft seal

Fig 1: Identifying Rear Camshaft Seal
GLL108989Courtesy of VOLVO CARS OF NORTH AMERICA.

Use drift 9995450 .

Lubricate the surface of the seal that the camshaft rotates against.

Press in the seal until the drift bottoms out.

NOTE:

If there are wear grooves on the camshaft the seal can be pressed in another 2 mm, by turning around the tool's sleeve.

Install camshaft adjustment tool 9995452 at the rear of the camshafts.

Check that the screws securing the adjustment tool to the camshafts and the screws holding the tool together are well tightened.

scientia non olet · About LEMON Manuals