LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - Removal, Replacement And Installation >> Cylinder Head (B5244S6; 2003-2006) >> Cylinder head/gasket, replacing >> Installing the cylinder head >> Installing the intake pipe for the coolant pump

Installing the intake pipe for the coolant pump

Fig 1: Identifying Coolant Pump Intake Pipe
GLL102980Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the inlet pipe for the coolant pump on the cylinder head. Use a new gasket.

NOTE:

Apply thread sealant, P/N 116 056, to the screw threads.

To clean the shaft journal and mating surface, use emery cloth P/N 951 1024.

NOTE:

Cleaning shall be done in the direction around the shaft journal, not in and out. It is very important that any residue from the emery cloth or any other contaminants are completely removed before the new seal ring is installed.

scientia non olet · About LEMON Manuals