LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - Removal, Replacement And Installation >> Cylinder Head (B5234T3; B5244T3; 2001-2002) >> Cylinder head/gasket, replacing >> Cylinder head gasket, installing >> Setting up the engine

Setting up the engine

Fig 1: Identifying Crankshaft Stop
GLL108952Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the crankshaft 

Remove the starter motor mounting screws. Pull out the starter motor and place it to one side.

Remove the blind cover plug

Turn the crankshaft slightly clockwise  .

Install crankshaft stop 9995451 . Ensure that it bottoms out against the cylinder block.

Turn the crankshaft counter-clockwise  until it stops against the crankshaft stop

Check that the marking on the crankshaft timing gear pulley corresponds with the marking on the oil pump.

scientia non olet · About LEMON Manuals