Installing the cylinder head

Fig 1: Identifying Cylinder Head Bolt Tightening Sequence

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ensure that all studs at the exhaust ports are tightened.

Lubricate the studs with paste 116 1408. 

Install a new cylinder head gasket.

Install the cylinder head

Lubricate and install all the screws. Use new screws.

Tighten the screws in the order illustrated

Tighten the screws in the following order:

1. 20 Nm 

2. 60 Nm  .

3. Angle tighten 130°  . Use protractor 9512050 .