Installing the carrier plate
Ensure that the mating surfaces on the crankshaft and carrier plate are completely clean.
Use 9995678 , which consists of 3 studs with nuts.
Install:
- The 3 studs belonging to tool 9995678 distributed as illustrated
- the carrier plate.
Check that the locating pin on the crankshaft is positioned opposite the hole in the carrier plate.
Align: 9995112 to the carrier plate.
Pull the flywheel towards the crankshaft using the three nuts on special tool 9995678 .
The carrier plate must lie against the crankshaft flange before the screws are installed. There is a risk that excess locking fluid on the screws will come between the mating surfaces.
Install 7 new screws. Tighten. See Summary of specific components and tightening torques .
Remove the 3 nuts and studs.
Install the remaining 3 new screws. Tighten. See Summary of specific components and tightening torques .
Install the engine speed (RPM) sensor with the bracket. Tighten.